Mitutoyo - Полный каталог инструмента - 2014 Английский язык

                                                           для размещения заказа - mitutoyo@mitutoyo-tools.ru
5. Wipe away any dust, chips and other debris from the circumference and

  measuring face of the spindle as part of daily maintenance. In addition,
  wipe off any stains and fingerprints on each part with dry cloth.
6. Use the constant-force device correctly so that measurements are
  performed with a consistent measuring force.
7. When mounting a micrometer in a micrometer stand, the stand should
  clamp the centre of the micrometer frame. Do not clamp it too tightly.

                                                                                                               B

8. Be careful not to drop or bump the micrometer on anything. Do not rotate
  the micrometer thimble using excessive force. If you believe a micrometer
  may have been damaged due to accidental mishandling, ensure that it is
  inspected for accuracy before further use.

9. After a long storage period or when there is no protective oil film visible,
  lightly apply anti-corrosion oil to the micrometer by wiping with a cloth
  soaked in it.

10. Notes on storage:
  Avoid storing the micrometer in direct sunlight.
  Store the micrometer in a ventilated place with low humidity.
  Store the micrometer in a place with little dust.
  Store the micrometer in a case or other container, which should not be
  kept on the floor.
  When storing the micrometer, always leave a gap of 0.1 to 1 mm between
  the measuring faces.
  Do not store the micrometer in a clamped state.

                                                                                 B-80

mitutoyo@mitutoyo-tools.ru www.mitutoyo-tools.ru