Mitutoyo - Полный каталог инструмента - 2014 Английский язык
для размещения заказа - mitutoyo@mitutoyo-tools.ru
Optional Accessories About the charge function Illumination (lx) Site (possible operations)
1500
(Only for models with data output function) The minimum illumination required in the
uncharged state is 60 lux. 1000 Design room, drafting room
05CZA624: SPC data cable with pushbutton (1 m) (Fine visual work)
58.50 As shown in the table at right, this SuperCaliper
can be used with confidence in a normal work 750 Conference room, control room
05CZA625: SPC data cable with pushbutton (2 m) environment.
70.40 500 (Usual manufacturing environment)
The charge function allows the operator to use
06ADV380A: USB Input Tool Direct USB-ITN-A (2 m) the SuperCaliper without interrupting work 300 (Normal visual work)
106.00 even if the ambient illumination is temporarily
insufficient. 200 Machine room, electric room, lecture hall
02AZD790A: SPC data cable for U-WAVE-T (160 mm) (Rough visual work)
52.20 In the fully charged state this SuperCaliper 150
can operate for approximately one hour in an Corridor, passage, stairs
02AZE140A: SPC data cable for U-WAVE-T and footswitch environment of 50 lux illumination (less than the 100 (Very rough visual work)
(160/500 mm) minimum necessary illumination intensity).
114.00 75
The time necessary for full charge varies according
to the charging conditions. If the SuperCaliper 50 Emergency staircase, warehouse
is left unused in an illumination of 500 lux 30 (Loading, unloading work)
(usual for manufacturing environments), it takes
approximately one hour to reach full charge. 20 D
Excerpts from JIS Z 9110 Artificial Illumination Intensity Standard
Air leak test equipment for water resistance inspection
Generally, an air leak test is used for evaluating water resistance.
Procedure: Place the measuring tool inside the capsule and seal it. Then fill the capsule and the test
chamber with air at the required pressure and close the isolating valves. If there is no leak in the
measuring tool, the differential pressure sensor will read zero, because the amount of air inside the test
chamber is unchanging. However, if there is a leak in the measuring tool, the differential pressure sensor
will show a non-zero reading due to a decrease in pressure inside the test chamber as air leaks into the
tool. By detecting this differential pressure, GO/NG judgement for the severity of the leak is performed.
This air leak test is performed for all coolant proof calipers and coolant proof micrometers.
Air supply
Isolating Isolating
valves valves
Capsule Test chamber
Differential Air leak test equipment for coolant proof caliper
pressure sensor
Master
Valve Valve
Mitutoyo operates a policy of continuous improvement that aims to provide the customer with the benefit of the latest technological advances. D-4
Therefore the company reserves the right to change any or all aspects of any product specification without notice.
mitutoyo@mitutoyo-tools.ru www.mitutoyo-tools.ru